This mould has been designed to create an Ashtray but this does not need to be its only use. It has an interesting topography which could lend itself as a template to create interesting pre-fabricated componants such as curved stringers etc.
Please note that all our moulds are hand-made and therefore the dimensions may vary by up to 2cm from those shown.
Creative Ceramics Moulds for Fusing, Slumping & Casting
Please Read: This firing recommendation has been calculated for use with Bullseye Glass of average viscosity with an even thickness of 4 - 6 mm. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc. If you are using a side firing kiln you must allow more time in the first ramp.
Please note that all our moulds are hand-made and therefore the dimensions may vary from those shown.